HD View12&HD View 6 It is suggested that all users always check our web site for the latest version of this Users Manual at www.key digital.com un
* Since the KD-DA6 and the KD-CDA12 are powereddevices they will produce a minimal amount ofheat, therefore it is recommended to leave enoughroom arou
There is no signal displayed on the “Display”device.Verify the Sync or Green connector on all of yourvideo connections; make sure it is connected to t
compatible with the “Display” device. Make surethat the “Source” signal is of a valid format that canbe displayed by the connected “Display” device;
When using the Digital Audio connection “PCM” orcoaxial audio, make sure that the “Display” device iscapable of decoding this compressed bit stream of
Metal Enclosure.Cost effective.2 years parts and labor warranty.Warranty:All Key Digital products are backed by a limit twoyear parts and labor warra
75 Ohm terminated Componenet Video.Audio: Standard “line” type high impendancetwo-channel, L, R. Each L or R could be usedfor PCM digital audio.Cable
The unit may be oriented horizontally, ormounted vertically on a wall. Use 2 #8 or M4screws to hang the unit (keyhole slots areprovided on the base of
UL LISTEDSafety Instructions – Please be sure to follow theseinstructions for safe operation of your unit*********************************************
Introduction:Welcome to the world of Key Digital’s Personal HomeTheater high resolution content distribution ampli-fiers. In today’s world where pers
Note before attempting to Hookup:The KDS-CDA12 and KD-DA6 have similar perform-ance and installation instructions. In essence theKD-CDA12 is double KD
input signal to all of the output connectors (the com-ponent video and audio output connectors aremarked “output” the KD-DA6 has one bank of 6(Marked
sure to use heavy shielded good quality cable likeKey Digital TechFlex heavy gauge AV cable (refer tomain catalog for cable selections, or KeyDigktali
The KD-CDA12 can be configured in 3 separatemodes:Mode1: 2 inputs each driving 6 outputs each ‡ 2X6Mode (factory Default).Mode2: 1 input driving 12 ou
inputs is for receiving the Source or input signal; theother input is used for the “Loop-Through” signal, forpassing the signal to the next amplifier
_1 2 3 4 _5 _6 7 8 SW1 OFF ON ON OFF ON ON ON OFF__________
Comments to this Manuals